S.E.R. FAQ
Home
Search
NotTaR of Television Sets : TV and monitor manufacturing quality and..  
 Copyright © 1994-2007, Samuel M. Goldwasser. All Rights Reserved. Reproduction of this document in whole or in part is permitted if both of the following conditions are satisfied: 1. This notice is included in its entirety at the beginning. 2. There is no charge except to cover the costs of copying. I may be contacted via the Sci.Electronics.Repair FAQ (www.repairfaq.org) Email Links Page.

     << No picture/dark picture/e.. |  Index  | Why can't TV manufacturer.. >>

TV and monitor manufacturing quality and cold solder joints

Any intermittent problems with monitors that cause random sudden changes in the picture brightness, color, size, or position are often a result of bad connections. Strategically placed bad connections can also cause parts to blow. For example, a bad connection to the SCR anode in a phase controlled power supply can result in all the current passing through the startup resistor, blowing it as well as other components. I had a TV like this - the real problem was a bad solder joint at a pin on the flyback. Thus, erratic problems, especially where they are power or deflection related, should not be ignored!

Bad solder joints are very common in TVs and monitors due both to poor quality manufacturing as well as to deterioration of the solder bond after numerous thermal cycles and components running at high temperature. Without knowing anything about the circuitry, it is usually possible to cure these problems by locating all bad solder connections and cleaning and reseating internal connectors. The term 'cold solder joint' strictly refers to a solder connection that was either not heated enough during manufacturing, was cooled too quickly, or where part pins were moved before the solder had a chance to solidify. A similar situation can develop over time with thermal cycling where parts are not properly fastened and are essentially being held in by the solder alone. Both situations are most common with the pins of large components like transformers, power transistors and power resistors, and large connectors. The pins of the components have a large thermal mass and may not get hot enough during manufacturing. Also, they are relatively massive and may flex the connection due to vibration or thermal expansion and contraction.

To locate cold solder joints, use a strong light and magnifier and examine the pins of large components for hairline cracks in the solder around the pin. Gently wiggle the component if possible (with the power off). Any detectable movement at the joint indicates a problem. With the power on, gently prod the circuit board and suspect components with an insulated tool to see if the problem can be effected.

When in doubt, resolder any suspicious connections. Some monitors may use double sided circuit boards which do not have plated through holes. In these cases, solder both top and bottom to be sure that the connections are solid. Use a large enough soldering iron to assure that your solder connection is solid. Put a bit of new solder with flux on every connection you touch up even if there was plenty of solder there before.


 <<No picture/dark picture/e.. | ToC | Why can't TV manufacturer..>>